Pioneer Avh X3600bhs Wiring Harness Diagram _hot_ Access

The standard 4-channel system is wired as follows:

3.5mm jack used for steering wheel control (SWC) adapters like the Axxess ASWC-1 or Pac SWI-RC.

Connects to the reverse lamp's positive wire to automatically switch the display to the backup camera. Pioneer Avh X3600bhs Wiring Harness Diagram

Many installers use an inexpensive, automatic 3-wire micro-relay. The relay automatically sends the required timed pulse signal to the radio right after power-up, safely enabling all menus for off-road or passenger use. Step-by-Step Harness Installation Procedure Step 1: Disconnect the Battery

The harness includes four pairs of wires for the front and rear speakers. : Front Left (+) White/Black : Front Left (-) Gray : Front Right (+) Gray/Black : Front Right (-) Green : Rear Left (+) Green/Black : Rear Left (-) Purple : Rear Right (+) Purple/Black : Rear Right (-) Specialized Signal Wires The standard 4-channel system is wired as follows: 3

Connects to a clean, unpainted metal chassis point on the vehicle. 2. Audio Speaker Wires

Prevent electrical shorts. Disconnect the negative (-) terminal of your car battery before touching any wiring. Step 2: Use a Vehicle-Specific Adapter Harness The relay automatically sends the required timed pulse

Reverse Gear Signal (For backup camera auto-switching) Speaker Wires White: Front Left (+) White/Black: Front Left (-) Gray: Front Right (+) Gray/Black: Front Right (-) Green: Rear Left (+) Green/Black: Rear Left (-) Violet: Rear Right (+) Violet/Black: Rear Right (-) Step-by-Step Installation Guide 1. Preparation

Do not cut your factory car wires. Instead, purchase a vehicle-specific wiring harness adapter that plugs directly into your car's factory plug.

The AVH-X3600BHS offers excellent flexibility for adding a subwoofer. It can drive a 4Ω subwoofer (or a 2Ω 70W subwoofer) directly on the rear speaker channels.

Never cut your factory car wires. Buy a vehicle-specific wiring adapter harness that matches your car make and model. Step 3: Match and Connect the Wires