Click the icon (an arrow pointing from the computer to a radio).
Enter your licensed frequencies in MHz. Ensure your radio matches the band type (UHF: 400–470 MHz or VHF: 136–174 MHz).
This is the most important part of the process. For each of the 16 channels on your TC-500, you can set parameters including:
Once the data is loaded, you can begin programming. The core settings are located in the section, where you can configure up to 16 channels. Key parameters to adjust are summarized in the table below:
Right-click on setup.exe or the main installer, select , go to the Compatibility tab, check Run this program in compatibility mode for Windows 7 , and click Apply.
Once upon a time, in a small industrial warehouse, a manager named Sarah had sixteen Hytera HYT TC-500
Open CPS → Click (or press F8) → Wait for “Reading completed.”
Plug the 2-pin programming cable firmly into the radio's accessory jack. Plug the USB end into your computer. Turn the radio volume knob clockwise to power it on. Step 2: Configure the Software Port Open the HYT HT500 programming software. Click on or Communication in the top menu bar. Select Com Port .
| Cable Type | Works? | Notes | |------------|--------|-------| | Genuine HYT TC-500 cable (USB or RS232) | ✅ Best | Includes internal level shifting | | Generic Kenwood programming cable | ⚠️ Sometimes | May fail to read/write; try slower COM port speeds | | FTDI chip-based USB cable | ✅ Good | More reliable than Prolific clones |
Open the HYT TC-500 Programming Software on your PC.
I can provide specific frequency profiles or walk you through advanced privacy code configurations based on your setup. Share public link
Install the software and ensure the for your programming cable is properly installed on your computer. Step B: Connect the Radio Turn off the TC-500 radio. Connect the PRG-50 cable to your computer's USB port.
Ready to Leave?
Select "Logout" below if you are ready to end your current session.
Click the icon (an arrow pointing from the computer to a radio).
Enter your licensed frequencies in MHz. Ensure your radio matches the band type (UHF: 400–470 MHz or VHF: 136–174 MHz).
This is the most important part of the process. For each of the 16 channels on your TC-500, you can set parameters including:
Once the data is loaded, you can begin programming. The core settings are located in the section, where you can configure up to 16 channels. Key parameters to adjust are summarized in the table below: Hyt Tc-500 Programming Software
Right-click on setup.exe or the main installer, select , go to the Compatibility tab, check Run this program in compatibility mode for Windows 7 , and click Apply.
Once upon a time, in a small industrial warehouse, a manager named Sarah had sixteen Hytera HYT TC-500
Plug the 2-pin programming cable firmly into the radio's accessory jack. Plug the USB end into your computer. Turn the radio volume knob clockwise to power it on. Step 2: Configure the Software Port Open the HYT HT500 programming software. Click on or Communication in the top menu bar. Select Com Port .
| Cable Type | Works? | Notes | |------------|--------|-------| | Genuine HYT TC-500 cable (USB or RS232) | ✅ Best | Includes internal level shifting | | Generic Kenwood programming cable | ⚠️ Sometimes | May fail to read/write; try slower COM port speeds | | FTDI chip-based USB cable | ✅ Good | More reliable than Prolific clones |
I can provide specific frequency profiles or walk you through advanced privacy code configurations based on your setup. Share public link
Install the software and ensure the for your programming cable is properly installed on your computer. Step B: Connect the Radio Turn off the TC-500 radio. Connect the PRG-50 cable to your computer's USB port.