Sc673-10 Ricoh Error Jun 2026

If you replaced the operation panel with a used unit from a different model, or if a technician flashed the wrong panel firmware, the controller will reject the panel, showing SC673-10.

And then, suddenly, the error message disappeared. The copier was back online, humming along smoothly. John breathed a sigh of relief as the office staff started printing out their reports.

Fluctuations in power can prevent the internal components from reaching a "ready" state in time. Troubleshooting Steps Cold Reset: Turn off the main power switch.

A:

This error typically appears immediately after power-on or during reboot, often with the machine hanging on the startup screen or displaying a blank panel.

If the machine was recently moved, bumped, or serviced, internal wiring may have shaken loose. Access the controller board area.

This "Flair" communication is a dedicated path that allows the Smart Operation Panel to exchange machine status information with the main controller. The error occurs when this communication pathway is disrupted; simply put, the main machine is not responding to the operation panel, or the panel's software is behaving abnormally. sc673-10 ricoh error

As John approached the copier, he noticed that it had been acting strangely all weekend. The machine had been jamming constantly, and the error message had started appearing intermittently. Now, it seemed to be stuck in a loop, beeping and flashing the error code every few seconds.

Turn off the main power switch (usually located under a plastic cover on the side or front). Unplug the power cable from the wall outlet.

Recommended for Service Technicians. End-users should contact their service provider. If you replaced the operation panel with a

A: No. The machine enters SC mode—it will not copy, print, or scan until the error is cleared.

To minimize the occurrence of the SC673-10 Ricoh error, follow these best practices:

The Ricoh SC673-10 error, while officially labeled as "Operation Panel Flair Communication Error," is one of the more manageable service codes you can encounter. In the vast majority of cases, it is caused by an incorrect SP setting (SP5-748-201) and can be fixed within minutes by entering the printer's service mode and toggling a single setting from "0" to "1". After that, a simple power cycle is often enough to get the machine back up and running. John breathed a sigh of relief as the

Follow this progressive diagnostic workflow to isolate and resolve the SC673-10 error code. 1. Perform a Hard Reset

Internal component failure within the touch screen assembly can prevent it from responding to the controller.