Dp Dual Trac 20 Assembly Instructions Full __full__ Online
Position the main upright mast onto the base frame. Secure it using the hex bolts and flat washers. Pro Tip: Tighten these bolts only finger-tight until the entire frame is assembled to allow for alignment adjustments. Step 2: The Seat and Rail System
The foundation of the unit provides the necessary stability for heavy lifting.
: This unit uses multiple cable lengths (ranging from 90 to 281 inches). Thread the cables through the pulley wheels, ensuring they sit firmly in the center grooves to prevent binding. For the Dual Trac 20, spring-loaded clips are used to easily swap between rowing bars, curl bars, and the ankle strap. Final Adjustments
: Regularly recheck and tighten frame and pivot bolts after the first few workouts, as they may shift during initial use. dp dual trac 20 assembly instructions full
The is a masterpiece of cable crossover engineering, but it demands respect during assembly. If at any step you feel uncertain—especially during cable routing—pause and watch an official DP video guide. Never force a bolt or a cable.
Feed the cable through the end of the swivel arm.
Choose a flat, level surface at least 8 feet by 8 feet. Position the main upright mast onto the base frame
Apply a thin layer of silicone lubricant to the guide rods now to ensure the weights slide smoothly later. Step 3: Weight Stack Installation
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Due to the weight and size of the main frame components, this assembly is a two-person job. Clear Workspace: Ensure you have at least a space for assembly. Step 2: The Seat and Rail System The
Assemble the to the front of the seat frame using the pivot pin and cotter pin. Slide the foam rollers onto the upper and lower tubes. Step 6: Cable and Pulley Routing (The Dual-Trac System)
Never force a component. If a bolt doesn’t thread easily, back it out and realign the parts. Most assembly errors come from rushing the base and upright alignment.
: Mount the main upright posts using carriage bolts and stabilizing plates. It is a common tip to hand-tighten only initially to allow for adjustments as you add horizontal bars and the roof/top section.
: Attach the leg lift assembly to the front of the bench or main frame as indicated by your specific model (e.g., Model #15-7000). Maintenance & Safety Tips
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
