V2000-c Rfid Access Control User Manual ((link))

The V2000-C uses a relay to control the door lock. Understanding the jumper settings is essential for configuring your specific lock type (fail-safe or fail-secure). The controller is typically connected to an EM lock, an exit button, and a 12V DC power supply.

Re-enter the to verify, then press # . Step 3: Setting the Access Mode

To perform any administrative tasks, you must first enter .

If you lose the master code, you can typically reset the system using an internal jumper. Power off the device. V2000-c Rfid Access Control User Manual

All programming is done directly on the keypad. The default is usually 123456 (or sometimes 0000). 4.1 Entering Programming Mode

The represents a benchmark in standalone security solutions. Whether you are securing a single-door office, a co-working space, a storage unit facility, or a high-traffic commercial entrance, the V2000-c offers a robust blend of durability, cryptographic security, and user-friendly management.

Once wiring is triple-checked, apply power. The V2000-C uses a relay to control the door lock

If you encounter issues with the V2000-C RFID access control system, refer to the troubleshooting guide below:

The V2000-C RFID access control system is designed to provide seamless and secure access control. Here's how to use the system:

The manual typically outlines three levels of user privilege: Re-enter the to verify, then press #

The Master Code is now restored to factory default ( 999999 or 123456 ), while user data remains intact. 6. Troubleshooting and Indicator Statuses LED and Sound Indicator Key LED Color / Sound Action / Status Access Granted Relay is activated; door is unlocked. Red LED Slow Flash Standby Mode System is armed and working normally. Yellow LED Solid Programming Mode Device is open for configuration changes. 3 Short Beeps Error / Invalid Input

To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults

You can assign unique User IDs (001 to 999 or higher) to keep track of individual tokens. Enter Programming Mode. Press 1 . Enter a 3-digit or 4-digit (e.g., 001 ) + # .