The ZK-5KX is built with robust firmware constraints to protect its internal circuitry and downstream loads. To modify these thresholds, long-press the from the home screen. Short-press SW to hop through the protection profiles, change values with the encoder, and long-press U/I to save your work. zk-5kx_voltage-converter.pdf - eleneasy.com
Master User Manual for the ZK-5KX DC-DC Buck-Boost Converter The ZK-5KX DC-DC Buck-Boost Converter
The term "ZK5KX" may refer to multiple hardware revisions. The procedures described are based on common industry standards for this model series. Always follow local electrical codes and manufacturer-specific safety warnings.
: Automatically turns off the output once a specific Ampere-hour limit is reached during battery charging.
The ZK-5KX is an electronic component. If it is not functioning correctly, check the power supply and all wiring first. Do not attempt to disassemble the module; there are no user-serviceable parts. Keep the module dry and free of dust.
79mm × 43mm × 48mm (Fits standard panel mounts)
The module will enter CC mode, providing constant current. As the battery approaches full charge, it will transition to CV mode and lower the current. 4. Safety Protection Mechanisms
The ZK-5KX is suitable for a wide range of electronics applications.
Press the button a second time to switch over to the current selection line ( SET A ).
: Short-press SW to cycle through Output Current ( A ), Output Power ( W ), Capacity ( Ah ), and Energy/Running Time ( h ).
: Cuts off supply after a precise amount of Ampere-hours has cleared the terminals (highly useful for battery bank top-offs). Enable/disable via a long encoder press. 3. Digital Calibration Routine
: Do not connect the VIN- and VOUT- lines together. Short-circuiting or bridging the input and output ground paths bypasses the onboard low-resistance current shunt resistor, causing the constant current (CC) limiting feature to fail.
The is a versatile digital control laboratory power supply module. It delivers an adjustable output voltage range of 0.6V to 36V and a maximum current of 5A , supporting workloads up to 80W .