Aodelan Wtr2 User Manual Jun 2026

Flashes green during focus confirmation and red during shutter release.

Sets a countdown timer before the first photo is taken.

The serves two purposes:

Slide the receiver into your camera’s hot shoe/cold shoe mount. Tighten the locking ring to secure it.

Confirms selections and allows you to edit fields. aodelan wtr2 user manual

Secures the receiver to the top of your camera.

2.5mm port to connect the camera shutter cable. 3. Getting Started: Battery Installation and Setup Follow these steps to safely power and connect your device.

On the receiver, double-press the power button to enter channel pairing mode (the LED will flash rapidly).

You want to wait 10 seconds, take twenty 5-second long exposures, with a gap of 2 seconds between each exposure. Flashes green during focus confirmation and red during

: Most settings can be adjusted with 0.1-second accuracy .

The interval time must always be longer than your exposure time (LONG), plus the time your camera needs to process and save the image to the memory card. 4. N (Number of Shots)

To create a time-lapse, you will configure the timer settings (represented by icons on the screen). Set the start delay (e.g., 5 seconds to get ready).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Tighten the locking ring to secure it

The WTR2 works up to 60 meters (196 feet) . You don't need a line of sight, as the 2.4GHz signal passes through most obstacles. Troubleshooting Common Issues

: A specialized mode for HDR. It automatically doubles the exposure time for each consecutive shot in a group (up to 7 frames). Shutter Release Modes

Press Start. The remote will hold the shutter open for exactly two minutes and then close it automatically. 6. Pro Tips for Success

Controls how long the camera shutter stays open.