Work | Fnirsi1014d Firmware Update

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Click . Choose "Yes" to format if prompted (this wipes corrupted systemic data).

: If the device fails to boot (backlight on but no image), you may need to remove the internal SD card, format it to FAT32 on a PC, and reload the correct firmware files directly. Community & Open Source Alternatives FNIRSI 1014D - How to do a Firmaware Upgrade Tutorial

Updating the firmware is the best way to unlock the true potential of this device. However, many users struggle with the update process due to poorly translated instructions or connectivity issues.

Depending on your hardware revision, the device will interface with your PC in one of two ways: Method A: USB Mass Storage Drive (Most Common) fnirsi1014d firmware update work

: Power off the device. Connect it to your PC using a USB-to-mini-USB cable. Bootloader Mode : Press and hold the

Delete all existing files on the oscilloscope's drive. Copy the new firmware file (must be named FSI-1014.bin ) onto the empty drive.

: Use a USB data cable to connect the oscilloscope to your computer. This public link is valid for 7 days

The FNIRSI-1014D requires a specific button combination to enter its bootloader state:

Open the drive. You will typically see system folders or existing system files. unless explicitly instructed by the release notes. Step 3: Transfer the Firmware File

on the drive to make room. Note: Back up any saved waveforms you want to keep, although a clean drive is best for the update. . 4. Copy the New Firmware

Wait 1 to 2 minutes for the process to finish. The lines on the screen should perfectly settle at the zero-volt baseline. ❌ Troubleshooting Common Update Failures Can’t copy the link right now

By following these simple steps, users should be able to successfully update the firmware of their Fnirsi 1014D device.

: Turn the device back ON . You should see the startup screen followed by a horizontal progress bar. This usually takes about 20 seconds to complete, after which the device will automatically reboot. Critical Issue: The "Shifted Screen" Bug

Download the latest firmware file (likely named FSI-1014.bin ). Ensure you have the correct version for your device's hardware revision. 2. Connect the Oscilloscope to PC Turn on the FNIRSI-1014D. Press the button. Select USB Export .