Older PDFs (e.g., 1963, 1986, 2002) are circulating online. ASTM E125 was significantly updated in 2018 and reaffirmed in 2023 .
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The ASTM E125 reference photographs PDF is a valuable resource for nondestructive testing professionals. By providing a standardized set of reference images, the ASTM E125 reference photographs enable technicians to evaluate the performance of magnetic particle testing equipment and techniques. This paper has provided an overview of the ASTM E125 reference photographs, their content, significance, and applications.
If you need this standard for your lab or project, the best route is to go directly to the source. Official Purchase: You can buy the standard and its accompanying adjuncts at Standards Aggregators: Sites like IHS Markit (S&P Global) also provide legitimate copies. Conclusion Astm E125 Reference Photographs Pdf
ASTM E125 is a standard reference blocks and photographs collection published by ASTM International. It specifically covers magnetic particle indications found on the surfaces of ferrous castings.
Hot tears (Plate I) are jagged, branching, and follow grain boundaries. Shrinkage (Plate II) appears as wider, spongy, or cavernous indications. The PDF photos make this distinction very clear.
Linear discontinuities are characterized by their length being significantly greater than their width. These are often the most critical defects because they act as severe stress risers. Hot tears, cold cracks, and shrinkage cracks. Older PDFs (e
(e.g., Hot tears, Slag inclusions, Shrinkage cavities)
While a direct, downloadable PDF of the entire ASTM E125 reference photographs is typically protected by copyright and restricted to purchase through ASTM International, the following article provides a comprehensive guide to understanding, accessing, and utilizing this standard.
– Foreign sand, slag, or oxide pockets trapped on or near the casting surface. This link or copies made by others cannot be deleted
Understanding ASTM E125: Standard Reference Photographs for Magnetic Particle Indications
is a critical standard published by ASTM International. It specifically covers the types and degrees of discontinuities that can be revealed by the magnetic particle inspection method on ferrous castings.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The standard divides magnetic particle indications into five distinct types based on the nature of the discontinuity. Within most of these types, the standard provides varying degrees of severity, typically ranging from Degree 1 (least severe) to Degree 5 (most severe). Type I: Linear Discontinuities