To ensure a smooth physical setup, compile the following assembly tools: Percussion drill and appropriate masonry bits Torx, flathead, and Phillips screwdrivers Metric socket set (for bracket hex bolts) Spirit level and spirit line or laser level Rivet gun (optional, for direct garage door panel bracing) 3. Assembling the Drive Rail and Operator
Verify that the door moves smoothly manually without binding or excessive friction. 2.2 Assembly and Rail Mounting
: Under applicable law, the installation of this automation device may only be performed by professional fitters. This manual is destined to professional fitters ONLY. Unauthorized installation by non-professionals may void warranty and constitute a violation of local regulations.
PR70 Document Version: 4.2 Pages: 10
: Unhinge the plastic front hatch cover and extract the primary housing cap by loosening the localized retention screws.
Open the door to the fully open position and set the Opening Mechanical Stop against the Drive Carriage (2). 3. Electrical Connections and Programming The PROBO PR70 utilizes the RG1 24V DL control unit.
: Garages without a second entrance require an ASEC PR device for outside manual release. To ensure a smooth physical setup, compile the
The following additional tips and precautions should be observed when using the Life Pro Bo PR70:
: Use the red button to enter settings; adjust with +/- buttons.
The release cord should be positioned at a height that is accessible but does not interfere with vehicle or foot traffic, typically no higher than 1.8 meters. This manual is destined to professional fitters ONLY
Installation must only be performed by qualified professional fitters.
The LIFE Probo PR70-07 / PR70-DL series features a 24V DC motor paired with an integrated optical encoder and electronic control unit. This configuration guarantees micro-precise positioning, intelligent obstacle sensing, and compliance with European safety directives. Technical Parameter Specification Value 230V AC, 50/60 Hz Motor Power Supply Maximum Thrust Power Door Surface Area Suitability Up to 9.0 m² Motion Transmission Reinforced Chain or Belt Lubrication Permanent Synthetic Grease Limit Travel Sensing Electronic Encoder + Mechanical Stops
Section 7: General Electrical Overview and Professional Installation Power Connection Requirements Open the door to the fully open position
