Js-visg-m-s Manual — ((install))

The hardware terminal blocks accommodate 2-wire, 3-wire, and 4-wire active or passive loop configurations. This makes it compatible with PLCs, variable frequency drives (VFDs), servo systems, and field control valves. Terminal Label Function Description Connection Type Positive power input line (DC 15-30V) Power Input GND Shared common ground for power and signals Power/Signal Ground A+ / AV Voltage signal output terminal (0-10V) Active Voltage Source I+ / AI Active current signal output terminal (0-22mA) Active Current Source I-MODE / AI- Passive current simulation control line Passive Current Loop Sink Active 3-Wire / 4-Wire PLC Connections

Depending on your project, you might not need a full 0-10V range. You can limit the output range via parameter : 0 : 0-10V (Default) 1 : 2-10V 2 : 2-5V 3 : 1-5V Adjusting Coarse vs. Fine Control (F001)

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Micro-USB 5V; draws 0.2A normally or up to 1A during battery replenishment. js-visg-m-s manual

The JS-VISG-M-S is no longer in active production. The primary distribution channels were e-commerce platforms like Aliexpress, but these listings are now obsolete. You may find new-old-stock units on surplus electronics markets or second-hand units on industrial auction sites.

: Sets value change step per pulse. Total change step is calculated as 1 F005 Fine Mode Tuning Step

comp.addLayer('waveform', source: src, color: '#1f77b4', strokeWidth: 2 ); The hardware terminal blocks accommodate 2-wire, 3-wire, and

0 : Display real electrical value (Voltage/Current) 1 : Display as an operational percentage ( 0.0% to 100.0% ) 2 : Display as a simulated frequency mapping ( 0.0Hz to 50.0Hz ) 0 Coarse Step Multiplier

: Accepts DC 15V to 30V. Consumes approximately 1W during normal operation or up to 5W when recharging an internal battery.

Set the value to (allocates three individual rapid-call slots) and click to confirm. You can limit the output range via parameter

Waveform layer:

Annotation layer:

Connect to the positive input terminal of the target monitoring device ( I+ ).

: Sets electrical barriers (e.g., in voltage mode: 0 = 0-10V, 1 = 2-10V). 0 F003

In this mode, the generator simulates a loop-powered transmitter utilizing the target system's power supply: Connect the external power source directly to the generator's terminal.