Fanuc Series Oitf Plus Programming Manual Verified

: P10 start block of the profile; Q20 end block; U0.5 stock left for finishing on X; W0.1 stock left for finishing on Z. Threading Cycle (G76)

G71 U(depth_of_cut) R(retract_amount) G71 P(start_block) Q(end_block) U(X_finishing_allowance) W(Z_finishing_allowance) F(feed_rate) Use code with caution. Radial depth of cut for each pass.

Use parentheses ( COMMENT ) heavily to inform operators about specific tool requirements or manual flip steps.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. fanuc series oitf plus programming manual

feature in Manual Guide i before running a part. [5.2, 5.14] USB/Memory Card: You can run programs directly from a USB or CF card via the DNC (Direct Numerical Control) function or "Load and Go" feature. [5.32, 5.35]

: Aligns parallel with the machine spindle centerline.

Peck drilling cycle for deep holes, fully clearing chips out of the hole. : P10 start block of the profile; Q20 end block; U0

Example:

Reserve structural sequence numbers ( N100 , N200 ) specifically for canned profile definitions or tool changes. Numbering every single line decreases file scannability and wastes processing memory.

This is the workhorse of any turning program. The manual provides a deep dive into the and Type II pattern repeats. Use parentheses ( COMMENT ) heavily to inform

The "Plus" variant brings enhanced processing speeds, a modernized user interface (iHMI), and better support for conversational programming through FANUC’s Manual Guide i . 2. Basic Program Structure

| G Code | Group | Function | Modal | |--------|-------|------------------------------------|-------| | G00 | 01 | Positioning (Rapid Traverse) | Yes | | G01 | 01 | Linear Interpolation (Feed) | Yes | | G02 | 01 | Circular Interpolation (CW) | Yes | | G03 | 01 | Circular Interpolation (CCW) | Yes | | G04 | 00 | Dwell (P or X/U address) | No | | G10 | 00 | Programmable Data Input | No | | G18 | 16 | Xp-Zp Plane Selection (Default) | Yes | | G20 | 06 | Inch Input Mode | Yes | | G21 | 06 | Metric Input Mode | Yes | | G32 | 01 | Thread Cutting | Yes | | G40 | 07 | Cutter Compensation Cancel | Yes | | G41 | 07 | Cutter Compensation Left | Yes | | G42 | 07 | Cutter Compensation Right | Yes | | G50 | 00 | Coordinate System Setting | No | | G70 | 00 | Finishing Cycle | No | | G71 | 00 | Stock Removal in Turning (Type I/II)| No | | G72 | 00 | Stock Removal in Facing | No | | G76 | 00 | Multiple Threading Cycle | No | | G83 | 09 | Deep Hole Peck Drilling (Z-axis) | No | | G96 | 13 | Constant Surface Speed Control ON | Yes | | G97 | 13 | Constant Surface Speed Control OFF | Yes | | G98 | 05 | Feed per Minute (mm/min) | Yes | | G99 | 05 | Feed per Revolution (mm/rev) | Yes |