Bosch Kl 1208 Manual !!top!! -

Connect the to the Negative (-) terminal of the battery (or to a solid, unpainted metal part of the vehicle chassis away from the fuel line if the battery is still grounded to the car).

If you are dealing with a faulty unit or need specific verification for an atypical configuration,Please let me know:

Since Bosch no longer produces the KL 1208, keeping your unit running is a DIY responsibility. Here is a maintenance schedule based on service bulletins from 2005-2010. bosch kl 1208 manual

For a second, nothing happened. Then, the KL 1208 let out a low, confident hum—a mechanical purr that vibrated through the workbench. The needle on the front gauge gave a rhythmic flicker, then slowly, stubbornly, began to climb.

: For standard lead-acid batteries, unscrew the screw-plugs and ensure lead plates are covered by at least 5mm of distilled water. Connecting : Connect the to the Negative (-) terminal of

The device is electronically protected against short circuits and reverse polarity . If a mistake is made, the charger will shut down immediately to prevent damage.

The charger may not start; check battery voltage with a multimeter. For a second, nothing happened

after the light goes out to complete the float/maintenance charge. Completion