What and Flash ID (FID) does ChipGenius show?
If your drive reports or fails to connect to AlcorMP, the controller cannot communicate with the NAND memory chip over the physical data bus. You can force the controller to bypass its corrupt initialization code and boot directly into a flashing state using a hardware test-mode short circuit.
The “F W FA04” part appears to be a firmware revision or internal model variant string that lsusb is pulling directly from the device descriptor.
Here’s one way to write it as a clear, technical description: alcor micro unknown fa00 f w fa04
If you run into any issues during the flashing process, tell me the exact your diagnostic tool outputs or the error code the MPTool gives you so we can find the exact version of the tool you need. ALCOR U2 MP v20.09.16.00 (6989SN-GTC/GTD/GTE/TA)
Using a precision needle or a small flathead screwdriver, gently bridge (short-circuit) two data pins on the (usually pins 29 and 30, counting from the dot indicator) while plugging the USB into the computer.
The "Unknown" status and the specific "FA00" firmware string are symptomatic of several failures: Firmware Corruption What and Flash ID (FID) does ChipGenius show
: Unplugging the USB drive during an active write cycle can scramble the controller's internal configuration blocks, throwing the hardware into a loop.
Find the . On most Alcor AU69xx chips, these are located on the side of the chip facing away from or adjacent to the USB connector (usually pins 29-32 or 41-44).
Visit specialized databases like USBDev.ru to find the version of that supports your specific FID. The “F W FA04” part appears to be
Locate and document the (Vendor ID), PID (Product ID), and the Flash ID (FID) string if visible.
command to see if the partition can be wiped and reset normally. Are you trying to recover data from this drive, or are you just trying to make it usable
When a flash drive degrades to this state, the underlying issue is rarely a simple software glitch. It usually points to one of three main problems:
Right-click the AlcorMP executable ( AlcorMP.exe ) and select .
This cryptic string is generated by diagnostic tools like ChipGenius and provides a detailed snapshot of your USB flash drive's controller and memory status. Here’s a breakdown of what each part means: