Perform calibration as required to ensure accurate readings or operations. 7. Troubleshooting Common Issues
The keypad includes an optical pry-off tamper sensor. If your system supports it, you can wire this to a 24-hour protective zone on the security panel to detect any attempt to forcibly remove the keypad from its housing.
: Supports cabling up to 1.5 km from the Challenger panel or Intelligent Access Controller.
The is a 3-LED Remote Arming Station (RAS) keypad designed for use with Challenger security systems. It features a robust construction suitable for indoor or outdoor use (rated IP67) and includes inputs for request-to-exit (RTE) control and an open collector output for door relays. Installation Steps for Tecom TS1162 Keypad
: The most reliable "article" and source for the full manual is the Tecom Manuals page ts1162 installation manual
For the most accurate and up-to-date instructions, it is highly recommended to consult the manufacturer's official documentation. You can typically find the manual on the manufacturer's support site or by searching for "TS1162 installation manual PDF" on official product portals.
💡 The manual’s emphasis on DIP switch configuration is vital; failing to set the 7th segment to "OFF" can trap the device in factory test mode, rendering it non-functional.
| Terminal | Signal | |----------|--------------| | L / + | Line (AC) / V+ (DC) | | N / - | Neutral / V- (DC) | | ⏚ (PE) | Protective Earth |
Proper wiring is crucial for accurate temperature readings and system longevity. Use a small flathead screwdriver to secure the terminal block connections. Perform calibration as required to ensure accurate readings
: Remove the two retaining screws from the bottom of the keypad body and pull the bottom away from the base to disengage the top tabs.
Proper preparation is the foundation of a successful installation. Before unboxing your TS1162, ensure your workspace and system environment meet all technical requirements. Tool Checklist Gather these essential tools before beginning the process: Phillips (#2) and flat-head. Precision Level: To ensure perfectly straight mounting. Wire Strippers/Crimpers: For clean electrical connections. Digital Multimeter: To verify voltage and ground safety. Power Drill: With appropriate masonry or wood drill bits.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Remote Arming Station (RAS) Keypad, 3 LED - Aritech
Remote Arming Station (RAS) Keypad, 3 LED * Robust moulded plastic housing. * Indoor or outdoor mounting. * Request to Exit input. aritech.com.au If your system supports it, you can wire
Use a multimeter to measure the voltage at the open collector output when it should be active. Ensure the output is sinking current correctly and that the connected load does not exceed the 10 mA maximum rating. Verify the door strike itself is functional with a direct power source.
Power should be turned off to the Challenger panel before wiring.
The keypad’s address is configured directly via its own keypad interface. Consult your main panel’s programming guide for the specific procedure on how to enter programming mode from the keypad to set its unique bus address. Once set, the main controller should automatically detect the keypad if its model is present in the system's device list. The Tecom TS1066 programming manual notes that if the model number (TS1162) is not auto-detected, you may need to manually select it from the system's list.
Are there any (like TS1162-A or TS1162-Pro) that we need to account for?
Connect the ground wire (usually green or green/yellow) to the grounding screw. Never skip grounding the unit. Interface and Signal Wiring
: There is a physical failure on the LAN data lines or a severe cabling short circuit. Measure the DC voltage across +12V and 0V to verify stable power delivery.