Use the second handle to turn the water on or off and adjust the flow volume.

Whether you have just unboxed the unit, are dealing with a sudden drop in pressure, or need to clean a clogged nozzle, these will walk you through installation, usage, maintenance, and troubleshooting.

Apply a non-toxic, caravan-safe antifreeze into the valve to protect any residual moisture from freezing.

Check that your caravan boiler or water heater is fully operational. If the hot water supply is fine, you may need to remove the thermostatic cartridge from the valve body and soak it in a commercial descaling solution for 30 minutes. Issue 3: Drips From the Valve Body After Turn-Off

The V200 typically allows you to switch between outlets. Note that on some digital models, only one function can be active at a time to maintain water pressure, while others allow combination.

Any work on the thermostatic mixing unit should be carried out by a suitably qualified competent person.

Arthur stood in his new bathroom, dripping wet and shivering, holding a laminated card that read:

: Ensure your caravan water pump or site supply provides balanced hot and cold pressures. 2. Mounting the Valve

The water cut off entirely. A turbine roar kicked on from the ceiling, blasting him with 80-mph heated air like he was standing behind a jet engine. His bath mat flew across the room.

I can provide tailored troubleshooting steps to fix your exact problem. Share public link

Connect the cold water line to the right-side inlet (usually marked with blue).

: It comes with brass threaded tails and chrome back plates. Ensure the hot supply is connected to the inlet marked "HOT" (or 'H'/red label) and the cold supply to the inlet marked "COLD" (or 'C'/blue label). Hole Centres : Standard fitting requires 45mm hole centres . System Requirements : Operating Pressure : 0.5 to 5 bar. Hot Water Temperature : 55°C–65°C. Cold Water Temperature : Below 25°C. Winterization (Drain-Down)

Apply a generous bead of high-grade, anti-mould silicone or a specialized caravan mastic sealing washer around the rear base flanges of the mixer valve body. This prevents shower spray from leaking behind the wallboard panel.

Loosen the internal plug to let trapped water escape freely from the internal thermostatic cartridge chambers.

Follow these steps to securely mount and plumb your Caraflo V200 shower valve. Step 1: Prepare the Mounting Wall Choose a mounting height comfortable for all users.

Turn off the main water pump and drain the hot and cold water storage tanks completely.