If you see an error, you might be too close (under 2 inches) or too far (over the max range). Check your batteries if the screen dims.
The Point-N-Measure Digital Tape W5746 features a 3-second power button hold for operation, auto-shutoff after 150 seconds, and requires 1.5V AAA batteries. It offers single-distance laser measurement, area/volume calculations, and unit switching between meters, feet, and inches, alongside a physical steel tape with a locking mechanism. For full operating instructions, see the 1pc Laser Tape Measure User Manual Alleenonline.nl Digital Measuring Tape - Alleenonline.nl
If the unit is not used for a long time, remove the battery to prevent leakage.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Point-N-Measure Digital Tape W5746 User Manual
is a versatile tool combining the accuracy of a laser distance measurer with the convenience of a traditional physical tape measure. Ideal for contractors, DIYers, and homeowners, it streamlines the process of measuring rooms, calculating area, and estimating materials.
Good for DIY projects like measuring for paint or carpet without a helper. Cons:
Store in a cool, dry place to prevent damage to the electronics. 6. Troubleshooting If you see an error, you might be
| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | Weak/Dead battery; Battery polarity reversed. | Solution: Replace with a new CR2032 battery. Re-install with (+) facing up. | | Display is faint or flickering | Low battery voltage. | Solution: Replace the battery. | | Measurements are inaccurate | Bent or damaged end hook; Tape is not straight; Kinks in the blade. | Solution: Inspect the hook and use pliers to straighten it if needed. Ensure the tape is straight during measuring. Replace the device if the blade has permanent creases. | | Tape will not lock | Lock switch broken; Internal debris. | Solution: Push the Lock switch firmly up/down. If it continues to slip, the internal lock may be broken. | | Tape will not retract | Dirt jam in housing; Spring mechanism failure. | Solution: Do not force it. Check for visible debris. If the issue persists, the device should be replaced. |
The Performance Tool Point-N-Measure Digital Tape W5746 is a 50-foot electronic, laser-based distance measurer designed to calculate area and volume without a physical tape. Key features include automatic unit calculations (feet, inches, cm), a memory "freeze" function, and auto-shutoff to preserve 9V battery life. For a detailed product description, visit Point-n-measure Digital Tape W5746 by Performance Tool 2004
Measure the , Width , and Height (three separate measurements). The screen will display the total cubic volume ( 4. Tips for Accurate Measurements This link or copies made by others cannot be deleted
Connect the included USB-C cable to the charging port on the W5746. Plug the opposite end into a standard 5V USB power adapter.
Locate the battery compartment cover on the back of the device. Slide the latch downward to release and remove the cover.
The device will display the total square units automatically. To Calculate Volume: Press the button. Measure length, then width, then height.